Lab Metallographic Cutting Machine Sample Cutting Machine Max Cut
Section 300x150 mm
The machine is a PLC controlled automatic metallographic sample
cutting machine, X/Y/Z directions controlled automatically and
precisely, intelligent cutting, the amount of feed can change
depending on the material’s hardness, to achieve the fastest
cutting effect. Cutting speed frequency conversion control, has
very high reliability and control ability.
- Manual/Automatic Cutting mode exchangeable
- Touch screen displays various cutting data.
- Precise positioning.
- Swing cutting and continuous cutting two cutting ways, according to
the material’s hardness, it can change the cutting speed, to
achieve the fast cutting effect.
In order to facilitate cutting room cleaning and security of the
spindle motor, the machine adopts electro-mechanical dissociation.
There is a large observation window on the cutting room security
cover, makes the user easy to observe the entire process of cutting
Installed LED lights in the cutting room, it achieves effective
lighting for the entire area of the cutting room.
Cutting indoor ventilation fan can ensure the efficient flow
discharge of various steam and smoke caused by the cutting and
increases the indoor brightness and clarity.
The design is more humane and adopts the principle of ergonomics.
The most important feature: Low noise, easy to operate, beautiful
appearance, safety use. It is one of the best equipment for
laboratory sample preparation.
The body form: vertical. Mainly composed of upper (safety cover),
middle (frame), right sliding door, side door, the lower frame
(electrical box, tool box), fixture, rinsing tap, cooling water
It adopts frequency conversion motor, direct cutting disc, stepless
speed regulation, concise design and solid structure. The direct
driving provides the transmission between the motor and the cutting
disc, and ensure the high efficiency, low noise, minimum
maintenance and longer service life.
Design of special cutting for large workpieces, it makes the
maintenance of machine parts and processing of large workpieces
easier. Sliding door and hinged door makes you have more space and
unlimited access, more convenient for you to place the large
workpiece in the right position. You can put the workpiece into the
cutting room from three directions (up, front and left).
The work area adopts fully enclosed structure and a transparent
protective cover for the observation of cutting. Equipped with a
cooling water tank for storing cooling liquid, do avoid using tap
water as cooling liquid. After the cutting work is finished, use
the left rinsing tap to rinse the indoor garbage and then close the
|Control method||Manual / Automatic, three axis linkage, 10 inch touch screen
control, Can be switched to the operating handle wheel|
|Feature||Automatic drain system, alarm system, double LED lighting, red
|Feeding speed||3mm/min, 5mm/min, 8mm/min, 12mm/min (users may modify the set speed
according to requirement)|
|Ø380xØ32x2 mm||Ø400xØ32x3 mm||Ø400xØ32x3 mm|
|Work table dimension (X*Y)||450x350 mm||485x400 mm||530x630 mm|
|Y axis maximum travel distance||250 mm||300 mm||420 mm|
|X axis maximum travel distance||100 mm||100 mm||110 mm|
|Z axis maximum travel distance||160 mm||230 mm||230 mm|
|Max. cutting cross section||120x100 mm||200x120 mm||300x150 mm|
|Fixture caliber||120 mm||200mm||300 mm|
|Frequency conversion motor||5.5kw, Speed: 500-2800 r/min||7.5kw, Speed: 500-2800 r/min||7.5kw, Speed: 500-2800 r/min|
|Feeding motor||Servo motor||Servo motor||Servo motor|
|Volume of the water tank||120L||120L||120L|